How to remove the note at left-down corner in Scopeview?

Submitted by Anonymous (not verified) on Wed, 05/18/2011 - 11:48
Forums
General Discussion

As a student in power engineering, I find EMTP and Scopeview are good tools for simulation. I have a question about Scopview here. When I wanna export waveforms from Scopeview to jpg file, there is always a small note at the left-down corner, which is “EMTP-filename”.

How can I eliminate this note in Scopeview?

Anonymous (not verified)

If you are using ScopeView 1.1 or later, follow these steps:

In the background  menu of the graphic page, choose the Page Properties... option.
In the Page Properties dialog, select the Legend tab.
Deselect the Visible check box.
Select the Apply To All button.

If you are using ScopeView 1.0, you cannot eliminate the note but there is a workaround if you are creating a JPG file containing only one graph. In the Export dialog, instead of exporting the graph using  the From All Pages option use the Selected option.

Regards,
Eric

Wed, 05/18/2011 - 11:49 Permalink
sphazamawaza

When I press on the scopeview after running the simulation, notjing happens. I know that Scopeview is supposed to open automatically after selecting it on the tab.

 

What could be the problem??

Regards,

Sipha Rubushe (MSAIEE), (Candidate Engineer ECSA)

BSc Engineering in Electrical Engineering (UCT)

MEng Candidate (Wits)

Sat, 03/31/2018 - 16:29 Permalink
X