Exchange Platform

Author: AdminEMTP-RV
Type: Model
Downloaded: 202 times
Date: 2012-06-18

3-phase_Statcom_Prel_Version

Description:
This is a three-phase three level Statcom model with PWM controller for use in transmission and distribution systems. It works quite well under severe perturbation.
The official version of this s... see moretatcom will be available in version 1.1 to be release in mid-june 2004.

Tag(s):

Author: AdminEMTP-RV
Type: Document
Downloaded: 522 times
Date: 2012-06-18

A Tool for Steady-State and Dynamic Analysis of PV Generation in Low Voltage Grids

Description:
Authors:
Dennetière S., Mahseredjian J., Duvauchelle C., Tounsi B.
This paper describes a tool based on EMTP-RV that simulates the steady-state and the dynamic behavior of photovoltaic (PV)... see more units on a low voltage grid. The tool takes into account load and irradiance curves to evaluate the impact of PV units on the voltage profile along the grid as well as the dynamic behavior of PV inverters. This tool has already been used to analyze and explain undesired disconnections of PV units in an existing system.

Tag(s):

Author: AdminEMTP-RV
Type: Document
Downloaded: 250 times
Date: 2012-06-18

On the implementation of a hysteretic reactor model in EMTP

Description:
Authors:
Sébastien Dennetière, Jean Mahseredjian, Manuel Martinez, Michel Rioual, Alain Xémard, Patrick Bastard

Abstract:
This paper presents the implementation of a hysteretic... see more reactor model in a transient analysis package. Themodel is available in a currently developed EMTP (DCGEPRI) version. It is demonstrated how the hysteretic reactor equations can be solved to eliminate topological limitations and allow solving large scale networks efficiently. Numerical robustness aspects and the representation of minor loops are emphasized. The model demonstrates new and not previously available computational capabilities.

Tag(s):

Author: AdminEMTP-RV
Type: Document
Downloaded: 464 times
Date: 2012-06-18

Presentation of an approach based on EMTP for the calculation of lightning induced overvoltages

Description:
Authors:
A. Xémard, P. Baraton, B. Bressac, N. Qako, J. Mahseredjian, G. Simard, J. Ribeiro, R. Tarafi, A. Zeddam.

Abstract:
LIPS (Lightning Impact on Power Systems) is a toolbo... see morex based on EMTP (DCG version) and devoted to the calculation of the failure rate of apparatus due to lightning. This software covers direct and induced lightning. It has been developed in a partnership project between France Telecom, Hydro-Québec and électricité de France. The induced lightning nearby the electrical system. It is based on the following computational steps:
1) For each overhead line and underground cable of the electrical system, two equivalent current sources are calculated in the frequency domain, representing the illumination of the conductors by external electrical field due to lightning. These sources are evaluated in the frequency domain, taking into account the variation of the parameters of lines and cables with frequency. The conductivity of the ground is taken as finite. The modal theory is applied in the case of multi-conductor cable or line.
2) The equivalent sources are converted into time-domain and then included in an EMTP representation of the system allowing a time-domain transient computation. this approach and follow by comparisons between induced overvoltages calculated by LIPS and results from the literature.

Tag(s):

Author: AdminEMTP-RV
Type: Model
Downloaded: 141 times
Date: 2012-06-18

Protection_Homopolaire_Evol

Description:
This case introduces a typical zero sequence relay tested in a MV network.

This is a contribution of Marc Petit from Supelec in France.

See the comments in the file.

Tag(s): Protection, Components