Hi there,
I am attempting to connect signals by name in my network but am getting this error/warning:
I am aware that connecting signals by name is normally not recommended, but it is the best way for me to do it as I'm using a script to run 1000+ simulations.
I have used this method previously with smaller networks with no issues, but for some reason it does not work with my newer, larger network.
Any help would be appreciated.
Thanks,
Harrison
Hi, Which script functions…
Hi,
Which script functions are you using to connect the signals ?
Best regards,
Jerome Cornau
Hi Jerome, thanks for the…
Hi Jerome, thanks for the response.
I have attempted to use both 'connectByName' and 'connectTo' functions. In the past, the connectByName function has worked for me, however, in this new larger network, a lot of the output files show no response. If I then move the signals closer together, and re-simulate, I will get a non-zero output.
The warning that I attached is displayed to me when I 'zap' the signals name. Also - I have the same issue as described above when I manually connect the signals by name.
Thanks,
Harrison
Could you send the model and…
Could you send the model and the script to support@emtp.com ? We will investigate it.
Best regards,
Jerome Cornau