How can one have the output data related to the ploted curves ?

Submitted by Anonymous (not verified) on Wed, 05/18/2011 - 15:51
Forums
General Discussion

I want to obtain the admittance matrix of an external system seen from boundary ports.
I would like to transfer the output data (including the magnitudes and phase angles) to MATLAB and fit them via Vector Fitting to obtain a frequency dependent network equivalent. In ATPDraw, the out file is putted in a *.lis file that can be used. Although in EMTP_RV, the output data (related to plot curves) is putted in *.m file and a *.mda file, but I don't know how use them. The *.mda file is not opened by office Access software. I really would be grateful if you can help me.Thanks a lot for your kind attention in advance.I am waiting for your reply soon.

Best Regards,
Babak

AdminEMTP-RV

Dear Dr. Mahseredjian

Thanks for your advice. This problem was solved. Now after obtaining a network equivalent as an input ATP file, I don’t know how import it in EMTP_RV. This is a part of my file:

BEGIN NEW DATA CASE
$DUMMY, XYZ000
$DUMMY, XYZ000
C  FIRST MISCELLANEOUS DATA CARD 
C  dT  >< Tmax >< Xopt >< Copt >
1.000E-6    .005              
C  BRANCHES         
:
:
However this format is for ATP and will be different for EMTP_RV. Where can I find the help of EMTP_RV about this format? and How can one import this format in EMTP_RV ?
Thanks a lot for your kind attention in advance.

Best Regards,
Babak

Wed, 05/18/2011 - 15:52 Permalink
Ahmed Daher

Indeed....How can we automate this task?(save data into ASCII). I'm working with the 2.2 version of EMTP and i can't find more information about that.

Thanks in advance for your help.

Fri, 06/17/2011 - 13:18 Permalink
X