Exchange Platform

Author: n.sene
Type: Publication
Date: 2015-04-01

Transient recovery voltages in vacuum circuit breakers generated by the early-interruption of the inrush current of large motors

Description:
The switching of medium voltage electrical motors is typically realized by means of vacuum circuit breakers (VCBs) essentially in view of their elevated number of switching cycles. As known, switching... see more of VCBs generates important transient recovery voltages (TRVs)
that need to be properly evaluated in both VCB sizing and in the power system insulation coordination. As large medium voltage electrical motors are installed into plants typically controlled by means of Supervisory Control And Data Acquisition (SCADA) systems,
maneuvers that involve the motor inrush followed by its sudden de-energization (due, in general, to the intervention of an automatic diagnostic function), resulting into important TRVs, are not unusual. The paper aims at investigating the TRVs due to this specific type of
VCB switching by means of a model implemented in the EMTP-RV simulation environment. By making reference to a real plant, the validation of the implemented models is obtained by comparing the simulation results with some experimental transients provided by the plant data fault recorder. The paper finally discusses the adequacy of different countermeasures by analyzing their effectiveness for the TRVs limitation.

Authors: A. Borghetti, F. Napolitano, C.A. Nucci, M. Paolone, M. Sultan, N. Tripaldi

CIGRE - International Symposium “Assessing and Improving Power System Security, Reliability and Performance in Light of Changing Energy Sources” Recife, Pernambuco, Brazil, April 3-6, 2011
Topic 3 – System technical performance
Subtopic 3.5 – Switching and lightning transient on power systems. Impact on performance and measurements

Tag(s): Transient recovery voltages, vacuum circuit breakers, motor inrush currents, EMTP simulations

Author: n.sene
Type: Publication
Date: 2015-04-01

Protection Systems Against Lightning-Originated Overvoltages in Resonant Grounded Power Distribution Systems

Description:
A joint research project between AES Sul, the Federal University of Itajubá and the University of Bologna aims at defining the required protections against lightning-originated overvoltages in a reso... see morenant grounded distribution system in order to achieve the adequate lightning performance level with minimum cost. The paper aims at illustrating the effectiveness of the presence of a surge arrester or spark gap and their protective zone by means of simulations obtained with a computer code for the calculation of lightning induced voltages that takes also into account the steady-state voltage. The results of a statistical analysis for a single multiconductor line are eventually presented and discussed.

Authors: A. Borghetti, F. Napolitano, C.A. Nucci, M.L.B. Martinez, G.P. Lopes, J.I.L. Uchoa

2012 International Conference on Lightning Protection (ICLP), Vienna, Austria

Tag(s): Lightning protection, power distribution networks, induced overvoltages.

Author: n.sene
Type: Publication
Date: 2015-04-01

Continuous-Wavelet Transform for Fault Location in Distribution Power Networks: Definition of Mother Wavelets Inferred From Fault Originated Transients

Description:
The paper presents a fault location procedure for distribution networks based on the wavelet analysis of the fault-generated traveling waves. In particular, the proposed procedure implements the conti... see morenuous wavelet analysis applied to the voltage waveforms recorded during the fault in correspondence of a network bus. In order to improve the wavelet analysis, an algorithm is proposed to build specific mother wavelets inferred from the fault-originated transient waveforms. The performance of the proposed algorithm are analyzed for the case of the IEEE 34-bus test distribution network and compared with those achieved by using the more traditional Morlet mother wavelet.

Authors: Alberto Borghetti, Senior Member, IEEE, Mauro Bosetti, Mauro Di Silvestro, Carlo Alberto Nucci, Fellow, IEEE, and Mario Paolone, Member, IEEE

IEEE TRANSACTIONS ON POWER SYSTEMS, VOL. 23, NO. 2, MAY 2008

Tag(s): Continuous wavelet transform, distribution network, EMTP simulations, fault location, mother wavelet, power quality.

Author: admin2012
Type: Document
Downloaded: 181 times
Date: 2014-06-02

Co-simulation Platform for the Analysis of Communication-based

Description:
The paper presents an ICT and power co-simulation platform for the analysis of the volt/var control and relevant optimization in medium voltage distribution feeders, achieved by means of a system of d... see moreistributed controllers coordinated via a shared band-limited digital communication network. The platform has been built by realizing the interface between two specific simulation environments: the Electromagnetic Transient Program EMTP-RV and the communication network simulator Opnet Modeller. The preliminary results provide basic indications on the expected performances of the considered communication-based strategies for different traffic congestion levels and load/generation dynamic variations.

Tag(s): Co-simulation, Networked Control Systems, Power distribution feeders, Volt/var optimization

Author: admin2012
Type: Document
Downloaded: 154 times
Date: 2014-06-02

SITL and HLA Co-simulation Platforms

Description:
Due to the necessity of developing analysis tools in the integrated ICT and power system domain, this paper describes and compares the architecture and configuration of two different ITC-power system ... see moreco-simulation approaches called SITL (System in the Loop) and HLA (High Level Architecture) Co-simulation platforms. Both platforms make use of the communication network simulator OPNET (Optimum Network Performance). As indicated by the names, the former operates in real time, in order to perform SITL simulations, whilst the latter is based on the HLA interface between OPNET and the power network simulation environment EMTP-rv (Electromagnetic Transient Program). We provide several details on their implementation and present their features by means of the results obtained for two test cases. The paper aims at clarifying the type of analysis that can be effectively carried out by using the two different platforms.

Tag(s): Co-simulation, OPNET, EMTP, High level architecture, System in the loop, Smart grid, OPAL-RT